SPE Extrusion Division 1-0-Wiki



Extrusion 1-0-Wiki Pages

Search the Wiki


Account Management


Brought to you by:
The SPE Extrusion Division
Board of Directors


Aligning a Blown Film Tower

Modified on Monday, 02 February 2015 01:26 PM by mpieler Categorized as Extrusion Hints
Aligning a Blown Film Tower
Vol. 27 #3, December 2000

When aligning a blown film tower, especially if it is a tall one that pops up above the normal factory roof, don’t forget to allow for a small amount of correction for tower movement, based on prevailing winds. In other words, if it is really windy out, wait until a day where it is pretty calm.

- Bill Davis, Poly-America

See also:
  • Pressure wash extrusion lines

Return to Extrusion Hints
Some of the icons were created by FamFamFam.