SPE Extrusion Division 1-0-Wiki



Extrusion 1-0-Wiki Pages

Search the Wiki


Account Management


Brought to you by:
The SPE Extrusion Division
Board of Directors


Check It Out

Modified on Sunday, 01 February 2015 01:02 PM by mpieler Categorized as Extrusion Hints
Vol. 16 #2, Dec. 1989 - Check it out

  • Check underwater pelletizer blades for corrosion.
  • Check to make sure that your heaters are actually supplying heat when the process temperature is below the setpoint.
  • Check the cooling water sump level it could be low.
  • Have you changed oil and filter on your gearbox lube system lately?

See also:
  • Cooling water
  • Gear pump lubrication
  • Underwater pelletizer

Return to Extrusion Hints
Some of the icons were created by FamFamFam.