SPE Extrusion Division 1-0-Wiki

RSS

Navigation

Extrusion 1-0-Wiki Pages

Search the Wiki
»

Viewing/Creating

Account Management

Administration

Brought to you by:
The SPE Extrusion Division
Board of Directors


PoweredBy
Water valve off
Vol. 22 #1, June 1995

When the zone temperature of the ex truder is reading way over the set point, check whether the cooling valve is closed or open.

It is possible that the cooling control valve was turned off by the operator and was not prop erly communicated to the next shift or the needle valve was plugged due to contaminants.

See also:
  • Cooling water
  • Cooling water flow
  • Water cooling
  • Water piping
  • Zone cooling check up

Return to Extrusion Hints
Some of the icons were created by FamFamFam.