SPE Extrusion Division 1-0-Wiki

RSS

Navigation

Extrusion 1-0-Wiki Pages

Search the Wiki
»

Viewing/Creating

Account Management

Administration

Brought to you by:
The SPE Extrusion Division
Board of Directors


PoweredBy
How to stop a vacuum pump
Vol.20 #2, July 1993

Sure you push the stop button ... and, in case of liquid ring vacuum pumps, steam and water comes pouring out of the extruder vent stack: The remaining vacuum in the pipes and vent dome is typically strong enough to pull the sealing liquid (mostly water) upstream into the extruder. As a consequence, the melt freezes immediately and steam leakage can cause a potential for injury.

A bleeding valve installed right at the vent dome can be used to break the vacuum, before the pump is stopped, and the problem of back flushing is prevented.

See also:
  • Vent bleed
  • Vent plugging
  • Vents 1
  • Vents 2

Return to Extrusion Hints
Some of the icons were created by FamFamFam.